Scott: I question that figure, 60001 would be early 1954. I know of two Super M bought in the spring of 53 and came with tyrods behind the axle. I know this as I owned one of them, bought new by my neighbor, and he gave me his bill of sale. He also told me of another Super M bought the same spring at same dealer. There must be a misprint.
I know the Super H came out in 53 a year behind Super M. I've seen lots of Super H with tyrods behind axle. In fact I've never seen a SH or SM with tyrods out front. My dad bought a H new in 51, it had tyrods out front. He had real alignment problems, IH dealer tried to solve them. Finally he agreed to trade him for the new front end. He didn't do it due to cash involved, however I know the H was only about 2 years old. I also know, IH dealer had a bunch of those old style wide fronts in stock, when the new was introduced. I know some of them were cut up for scrap (NEW) 15 years later.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.