Posted by Dustin Bench on June 13, 2009 at 16:54:13 from (72.19.158.251):
Hi everyone. I have split the rear sections of my 300 utility, pulled the transmission driving gear and exposed the needle rollers (overrunning clutch rollers?) Now I have a problem. I don"t have any idea how to get the seal out to replace it. Also, I"m concerned about how I"m going to get the needle rollers back in without them falling apart. This is the one with 8 rollers and needles. Any help is very much appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Pefect Collection - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I thought it would make for some interesting discussion for many of you to post what would be considered your dream or perfect antique tractor collection of five tractors, assuming room for storage and cost were not a factor. I have posted my "Perfect Collection" on the Farmall board. List any brand preference but keep
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
