Posted by DJL on May 01, 2009 at 20:15:16 from (65.172.101.94):
Well, I'm slowly making some progress. I spent about 2 hours pressure washing all the old grease/grime/dirt off of the old girl today. Pulled the sickle and the guards and got both ordered from Case/IH dealer. I'm going to replace the whole shootin' match. So a couple of questions, the Case/IH dealer couldn't find exactly the right match on the sickle hold/downs (for lack of a better term) the half loop deals that hold the sickle down to the bar and running close to the ledger plates. Anyone know a part number? They had a couple I could look at but not exactly the same size/type. Also, I popped the small access cap on the wobble box and found one grease fitting in there and gave it 2 pumps of grease. Is that the only one in there? Also, is there supposed to be any gear oil/lubricant in the wobble box itself, or just the grease fitting? Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
