Posted by Matt Wech on April 25, 2009 at 18:28:29 from (216.222.248.57):
In Reply to: Hey, Matt Wech! posted by ScottyHOMEy on April 22, 2009 at 16:45:39:
The email notification dropped off and I didn't know it!! oops. I still don't have spark. The guy used a regular house type light switch to rewire the coil. It lights up and finished the circut as it should, I put the meter on it and it is showing power out. But it stops at the coil. Does the coil feed from the magneto? If so, could the mag. be rusted and dirty not allowing the power through to the coil? Also, if I get the mag working properly can I elminate the coil and go direct from the mag to the starter? My goal is to get it to at least fire and run for a minute or two by the end of the month.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
