|
Farmall & IHC Tractors Discussion Board |
Re: 3 Point Attachment for Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Brian Schmidt on April 06, 2000 at 19:01:46 from (216.178.176.35):
In Reply to: 3 Point Attachment for Super C posted by Linda on April 06, 2000 at 17:10:06:
The one I have on my C is from Saginaw County Tractor. It mounts to the rear axle and uses hydraulic oil from the tractor to raise and lower it. It is much better than the Worksaver version because it is hydraulic and does not use arms to the cultivator arms on the tractor. Mine can also be put in float mode for final grading or mowing. Quite nice hitch and is one of the most inexpensive ones on the market. Mine was about $500. Here is a link to the site. They don't talk about the C on there, but they do sell them. Give them a call and ask.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
