Posted by spiffy1 on January 24, 2009 at 20:45:46 from (70.41.137.72):
In Reply to: mccormik deering 10-20 posted by 1941FarmallAboy on January 23, 2009 at 13:25:14:
DAN DOYLE said: (quoted from post at 22:33:25 01/24/09) SO IF IT COST A LOT TO TAKE IT APART SHOULD I JUST TRY TO GET THE PLUGS OUT AND SOAK IT TO FREE IT UP AND THEN TRY TO GET HER RUNNING OR WHAT DO YOU THINK THANKS
It doesn't really costs too much to pull the head, but sure can lead to "price creap" [$50 spent doesn't make $100 more seem too bad, which doesn't $500 ect.]. I think the head gasket is under $50 and the whole top gasket set is under $100.
So, it depends upon your intended use as well as the history and present condition.
For "Sunday drives", why not try soaking it first while it's all together?! Even slightly beyond that, if you don't see any reasons that it may have to come all apart [hand hole gaskets are real cheap, if they even need to be replaced so you may as well peek inside], it cost nothing to try a little soaking time first.
If it doesn't cooperate, pull the head - and stop wherever your gut or checkbook lets or makes you! 8)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
