Posted by CNKS on January 10, 2009 at 09:03:59 from (216.144.104.128):
In Reply to: Re: Hugh Mackay posted by Hugh MacKay on January 10, 2009 at 02:47:52:
366294 is an assembly with all the parts, 366204 is the block number. I am not sure, but I don't think in that case it is a replacement block -- because it gives a serial break. Which implies that more than half of the C's actually had C123's with thicker sleeves to maintain the C113--not saying that's the way they were, but it is the way I read the manual, which does have a few mistakes. I haven't gotten into the R1,2, etc, because I'll worry about that if and when I rebuilt my C and Super A engines. What I have learned from this an other similar discussions is that one size does not fit all, which will then be helpful.
This post was edited by CNKS at 09:07:33 01/10/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
