Posted by J.J. from Afton on January 06, 2009 at 20:17:30 from (12.208.127.84):
In Reply to: F-14 A Farmall posted by mvanderveer on January 06, 2009 at 17:38:07:
Best bet for finding tires for those rims is placing an add on this site or watch ebay. You will likely have to search far and wide to find used ones. The modern tire size is 9.5x40" and new ones cost about $525 each. Other thing to do is find a different set of rims and tires like Andy mentioned, but not neccasarily gonna save a whole lot going that way, all depends on the deals you are able to find.
As far as steering id it could be either one, best way to check serial number on the engine and see if it matches that on the tractor, than see if it falls in the range Scotty mentioned. Like others have said, your tractor could have been made that way or could have been farmer modified, wouldnt be the first and wont be the last.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.