It was DISTRIBUTED BY 411 TECH SOFTWARE. I have two of these one for my A and this one for my SC. It has the operators manual. the operators manual on page 19 starts with operating the Hydraulic remote control system and it goes for at least 10 pages. It talks about setting depth with the collar on the ram, break away coupling for the FH. Raising and lowering the FH equipment, operation of the FH system. control levers, coupling implements, hitch adjustments, hitch load limits, draw bars. It tells about everything you need to know about the FH and how it is operated. My cd also has the parts book with diagrams of breakdown. I used it to rebuild my hydraulic pump and my remote cylinder.
This CD will give you EVERYTHING you need for repair, parts, and operating your SC with a FH. I like the CD because I can print off the paper take it to the place I am working on the tractor and if I get oil or grease on it, it is ok, I can print another one. I looked on Ebay but I could not find that company, keep your eyes pealed and they should post some more I would think. good luck. Ron
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
