Posted by Oak Dale on December 18, 2008 at 11:46:03 from (76.79.44.52):
In Reply to: Soldering advice posted by DRC on December 18, 2008 at 08:45:40:
I'm in 100% agreement with everybody: The metal must be absolutely CLEAN before you try anything else.
I'm an old retired 'shop' teacher, and I've taught many folks how to solder. Here is my advice for you on this one. Since you haven't soldered much before, practice on some scrap first! There is a 'trick' to soldering. You have to learn to get the metal hot enough, but not too hot. The old timers say you have to learn to see the solder 'sweat'. I agree. You can only learn to see this by practicing. If the metal is too cold, the solder will just ball up and laugh at you. If you try being a heat bully, the solder will ball up and laugh at you. When it is just the right heat, the solder will 'sweat' or get shinny, and flow out on your nice CLEAN fluxed surface and 'tin' it with a nice thin layer of solder. A little brass brush can be a real help to get the tinning solder to go where you want it and to get stubborn spots to 'take.' Once the two metal surfaces are 'tinned' they can be joined together much easier than if you try to tin and join all at once. Any experienced solderer can do this, but it is just so much easier to tin and join in two steps.
Whatever you do, try it! The guys are right - keep the rest of the core cool so you don't melt away anything good. But go for it. Once you learn how, you'll be rewarded with lots of opportunities to use the skill. And, it is fun to do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
