Posted by GordoSD on December 11, 2008 at 17:52:51 from (66.115.200.140):
From the old threads you may recall I am installing PS on the SMTA. I was looking for an M shaft so I didn't have to cut off a SMTA shaft. I found one today, 3 miles from here in a fence row M. And it will work, it's about 2 inches shorter than a SMTA shaft.
Now the best part. The radiator on that M is pristine. Not a bend, mark on it. Of course we don't know if there are tank leaks. But I've never seen a radiator with absolutely no damage to any of the cooling section, hood clips are sanitary, bolt holes immaculate..
Here's one to take to a shop, boil, test and install. I'll go over there, lay in the snow, fight those lower stud nuts and cotter keys,and get it out for one of you lucky guys, BUT who needs it at what offer? Fits M, SM, SMTA, and 400/450?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
