Posted by mkirsch on November 14, 2008 at 21:54:30 from (64.80.108.52):
In Reply to: CUB vs BN posted by 686142 on November 14, 2008 at 06:53:53:
Now here's one bit that nobody's even touched on yet: Implement Availability.
Unless you get the implement you want WITH the BN, you're not likely to find it. While the tractor does have a standard PTO, most implements were still proprietary to the BN, and nearly all of those implements have gone to the scrappers in the last 60 years.
You can still get a Woods 60" deck to mount on it, but it will cost many times what you paid for the tractor to purchase new. I've seen a few Bs with mower decks, and a handfull of B/BN mower decks with mounting hardware for sale, but not many.
There's a whole dedicated market for Cub implements and attachments, on the other hand, and many more Cubs on the market compared to BNs. I'd estimate about 50% of Cubs come with some form of mower attachment, and Cub mowers come up for sale frequently.
Another advantage to the Cub is the hydraulic lift. Most Cubs have it, and those that don't can have it added easily enough. With a BN, unless you luck out and find one that has had a Super A or Super C engine installed, you need to cobble up an old power steering pump driven off the fan belt to get pressure. Then you need to obtain a valve, reservoir, cylinder, and hoses, and fabricate a lift mechanism. Otherwise, you use the "armstrong" lift, if you can find one. Also available, but rare, are pneumatic lifts for the BN, but they kinda slam the equipment to the ground, and are very slow to lift.
If you can find a BN equipped the way you want, then by all means go for it over the Cub. But, if your desire is to take a bare tractor and buy the implements for it, the Cub is the better choice.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
