I do not think it is part of a watershed program. I did not notify anyone before I started the project of clearing, nor when I had it logged last October. I am still dragging out brush that the loggers pushed into the creek to make their crossings (2x). I know that it can fill to the brim, but that was due to the Parish (County) road culvert failure. It has since been replaced.
I agree on the size, I had estimated a 60". I am thinking of trimming the upstream side of the culvert on an angle and building a trash screen out of pipe. This should keep it from jamming up as bad or getting something stuck inside.
I have probably violated half a dozen codes or more since I started this in 2006. It may come back to bite me when I start to obtain building permits and inspectors come. One good point is the Police Jury rep lives down the road from me. In Louisiana, the Police Jury is over all roads outside of any city limits.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
