Posted by ScottyHOMEy on October 02, 2008 at 11:32:22 from (71.241.192.129):
In Reply to: Re: Farmall A or B? posted by ScottyHOMEy on October 02, 2008 at 11:01:23:
The narrow fronts of the Bs were entirely different castings from the wide front As.
Two ways to make that kind of "hybrid" I mentioned. 1) Shorten up the left side of a B/BN with the shorter differential shaft from an A and eliminate the need for the longer housing or 2) start with an A and replace the whole front casting with that from a B/BN.
If you have such a beast, the model on the Ser# plate will tell you which way it was done.
I've heard it said that there was a factory option for a wide front on a B (never seen one, just been told) but I've never heard of the factory putting a narrow front on an A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
