Posted by Hugh MacKay on September 29, 2008 at 02:35:01 from (216.208.58.119):
In Reply to: Log pulling posted by EDW on September 28, 2008 at 19:54:49:
EDW: Care must be exercised pulling logs with a tractor, particularly light tractors like a SC. Problem is the log catching something on or just under soil surface. If going to fast it can flip the tractor. Secondly and this applies to short logs in particular, I have seen them dig in causing them to flip on tractor. Luckily the one I saw happen, landed on 560 axle between wheel and operator's platform. For that reason I prefer full length trees at least 20', longer is better.
Another thing you can do is what my dad called snouting the tree, and he did this in the days of horses to make it easier on the horse. With an axe or chain saw he'd put a taper on front end of log, front end being direction pulled. Just go right around tree, give it a sled runner effect. This I would do, particularly with a light tractor.
I've skidded hundreds of thousands of logs with horses, Farmalls 130, 300 and 560, then finally a Deere 540A forestry skidder. It never gets much safer, you just increase production to pay for the bigger machine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.