Posted by the tractor vet on September 17, 2008 at 14:02:54 from (75.19.124.96):
In Reply to: 1256 rear end posted by acdave on September 17, 2008 at 12:59:37:
Yes some did and some did not. All i can tell ya is to check the hyd. filter and dain and check the bull gear oil , now if there is no fill plug on the back side of the axel housing then you will need to drain all the oil out of the rearend and also the bottom plugs on the axle housing. As at this moment i think CRS is taking hold as i can not remember if a 56 series has fill plugs or not old age sucks . But unless ya find peices and parts coming out RUN IT. She will let ya know when she needs fixen.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
