Posted by Joe Henry on September 08, 2008 at 07:40:07 from (12.3.145.60):
I have a pretty simple inquiry. I have a 1942 Farmall H that has a 1 1/8 size PTO shaft. Is this the standard/original size that the tractor would have come off the line with? A few fellows have been telling me that it should have had the standard 1 3/8 size.
On another note, I have been using an increaser adapter (1 1/8 female to 1 3/8 male) to hook-up up to a pull behind bush hog. I have managed to blow apart two of these increasers in the past couple of weeks, but haven�t done any (maybe a little minor) damage to the PTO shaft or the bush hog. Any suggestions? Are there 1 1/8 sizes yokes out there that I could just swap out from the bush hog (which currently has a 1 3/8 size yoke) so there is then no need for an adapter?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
