|
Farmall & IHC Tractors Discussion Board |
Re: Put on your thinkin' caps.
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by MrG:Hay Sweeps on March 20, 2000 at 13:59:05 from (216.170.12.242):
In Reply to: Put on your thinkin' caps. posted by MoosieDog on March 19, 2000 at 21:08:03:
Don't know if they still do it, but probably not do to more modern hay handling methods.... Out in the Nebraska Sandhills during the 60's, I worked for a rancher stacking loose hay as it came over the top a slide stacker. The hay was gathered from the windrows to the stacket by "sweeps". These were 8N Fords that had been reversed almost exactly as you describe you want to do to your 240. A large wooden tined sweep was mounted on the rear (now front) 3pt and the driver chased the windrow till the sweep was full then pushed it to the stacker. The seat was mounted to the right of the engine facing rearward. The brakes pedals were not moved as they were still in the general location of the right foot. The clutch though, still being on what was the left side of tractor, was actuated by a new pedal that was mounted to an actuator and a rotating rod that ran under(?) the tractor and over to where the rear facting driver's left foot would now be. Just recently, a friend of mine south of Grand Island had acquired an older Allis (WD?) that was set up like this. He had a hard time selling it because it had outlived its usefulness as a sweep, and the AC collectors/restorers didn't want it because it was too cobbled up to return it to its original condition as a rowcrop tractor. I'd hate to see you destroy was is otherwis a neat little tractor. If you would like, I'll go look around out by Thedford and Brownlee for an 8N sweep your can race around backwards with, and trade you for your 240. :-) G
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
