Posted by Steven f/AZ on August 14, 2008 at 07:03:36 from (216.67.213.217):
In Reply to: PTO speed on an H posted by LA in Wi. on August 14, 2008 at 06:18:53:
LA in Wi. said: (quoted from post at 06:18:53 08/14/08) I talked him into letting me on that H, I reved it up and his eyes got big for fear over his baler, but we never broke a pin after that.
LA in WI
Sounds like my Father-in-law... he complains about his vehicles not having any power, so we go for a drive with me behind the wheel... I hammer it to the floor and we lay rubber and accelerate at a quick pace - his eyes get big and he says I'm going to blow the engine and I'm wasting fuel. I respond with "If it blows up, it was going to anyway and it takes fuel to make power!"
If you hurt your baler running it full throttle with an H, it was bound to break anyway.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
