Posted by xnhfkdkmx on August 09, 2008 at 20:45:23 from (70.239.222.153):
In Reply to: F-20 engine build posted by spencer13cat on August 08, 2008 at 19:14:06:
Thanks guys, once I get the details figured out I will post my findings. I hope this helps others in the future. My buddy suggested looking through the catalogs of piston mfgrs and look for one that would work with the wrist pin and deck height. Sounds like the MH44 idea mentioned above.
That brings up another thought. It seems like the compression of the originals is really low. I realize there are three set of originals but have never seen diminsions or compression ratios. what compression are the newly mfgd pistons? What compression ratio have you guys tried and what were the results? I am assuming everyone runs regular unleaded gas???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
