|
Farmall & IHC Tractors Discussion Board |
Super A plow alignment? Hickupping Hydraulics????
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by p on March 18, 2000 at 22:53:39 from (205.188.197.162):
I installed the molboard plow on my Super A today. I swithched the drawbar, I don't have the draft control bar so I used a chain. As I attached the plow to the drawbar I began to contemplate a few problems. The biggest is where do I bolt it to the drawbar. Above or below, and in which set of holes. I put it on top of the drawbar and as far right(if in drivers seat) as it could go. Is this correct? Also, I forgot about the hydraulics, they work fine but when I put a load on them and leave them to support it they slowly sag and then quickly recover. This leaves what I call a hickup. it is up, the plow sinks about an inch and it bounces back up???? can this be adjusted out, (it has been like this for the 15 or so years we owned it but I have not had anything on the hyrdaulics in years. Thanks for ANY info...p
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
