Posted by Kevin LA-CA on July 18, 2008 at 21:13:42 from (71.189.218.168):
In Reply to: easy question posted by Bob S. on July 18, 2008 at 08:21:21:
Bob
If this is an older loader & cylinders - many can be fixed by tighten a packing. I have seen threaded packing nuts (like old time shaft packing e.g. water pumps) or retaining rings with 4 bolts.
If so, the packing can be replaced without dismantling anything. Find a replacement packing at an old time dealership if you have one around. Extend ram 6 inches or mpre(and support bucket safely). Remove packing nut or ring. Remove the old packing. Cut the new packing one at 45 degrees and install. Tighten packing nut or ring until it doesn't leak.
If loader is newer with rubber lip seal or o-rings you will have to dismantle more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
