Farmall & IHC Tractors Discussion Board |
Re: b head bolt torque
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Farmer Bob on March 14, 2000 at 19:58:45 from (207.227.187.150):
In Reply to: b head bolt torque posted by stillcrazy on March 14, 2000 at 07:25:14:
Still, Head bolts should be torqued to 65 lbs. I'd take them to 40-45 lbs. then to 65 lbs. Use the criss-cross pattern starting in the middle and work towards both ends. On the pulley, even though your question was encrypted, (If your's is on I wondered why you were asking), Put the pulley in your wife's oven and heat it up to about 350. There should be threads on the inside of the end of the crankshaft where the pulley goes. Find a long bolt with the proper size threads and washers to use to "pull the pulley" onto the shaft. Get everything lined up and get the pulley started onto the shaft. Stick the bolt with washers at the head of the bolt in through the pulley and into the threads Turn the head of the bolt clockwise to pull the pulley on. Don't forget to use heavy mitts when handling that hot pulley. Have a pail of water and some rags handy so you can soak down the pulley after it is in place to lessen the heat damage to your seal.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|