Posted by sflem849 on June 14, 2008 at 15:00:52 from (24.240.83.158):
I don't remember the year, but the other guy that went and looked at it with me thought 44. It is a one row cotton picker on an M that is on steel. It is still 6 volt with a DuPont overhaul (not so great). The fellow started it up for me and it started and moved good. What do you think it is worth? I was thinking less than you might think. I think there are three big negatives that will hurt it's value. 1 - No cotton to pick in WI. It is always fun to use the tractors we have and you could never do that. 2 - It is on steel. I know that is a plus to some, but it is a neg to me. I can't take it anywhere! I buy mine to use. 3 - IMHO it is too tall to take on the trailer. You might be able to fit it on a "car trailer" type, but never on a typical gooseneck. I think you would take down every powerline on the road. It of course has all the pluses as well, but those are more obvious.
To all who may be interested it looks like a heck of an IH auction. The old fellow had about a dozen and only two were on rubber! I think I have my eye on the Super W-6 and the 400. If you would like to go it is Sunday the 22nd in Sharon, WI.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
