Posted by Janicholson on May 04, 2008 at 19:28:39 from (64.83.197.92):
In Reply to: Flywheel - 1940 M posted by Ave on May 04, 2008 at 19:20:18:
Repeated from page 4..JimN New pilot bearing, or accurate measurement of the existing bearing to assure it is OK. New plate, new TO bearing. Resurface flywheel friction surface, and take the same amount off of the rim where the clutch PP mounts to the FW. this keeps the geometry correct. Take out three of the PP mounting bolts equaly around (120 degrees apart)use the three to screw into the rear of the PP where there are three holes of correct thread. These bolts release the PP clamping force from the FW. this allows the pp to be released while putting the engine in. after assembly the bolts are re installed in the FW, after putting in the shaft. JimN
the tractor vet
Re: New Clutch Disc for Super M in reply to Janicholson, 05-03-2008 16:30:18
Now when ya reface the flywheel there is a specific hight that the step needs to be cut to . as a lot of places do not know this and this is why alot of clutches slip. the correct step hight should be 1.406 . write that sown so ya don't forgot .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
