Thanks to all for the suggestions. I'm going to repeat the continuity checks on the gen and field wires to the generator posts; but this time I'm going to check them with the wires disconnected from the VR to make sure I'm getting no feed through the VR. I am now wondering if the field and arm wires are crossed with each other at the generator? That would explain the full "discharge" when I jump the VR from the batt to the gen posts. mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
