Posted by Tractorfan1 on April 09, 2008 at 10:47:06 from (142.167.92.156):
In Reply to: war time shift knobs posted by edward_m on April 08, 2008 at 23:02:54:
edward_m said: (quoted from post at 23:02:54 04/08/08) It's REALLY rare on non-wartime IH's....it was only used for a few years, and discontinued after the war. So they shouldn't even show up on anything before or after the war.
It was supposedly started in '43, and ran thru to '45. Didn't happen in '42, as rationing hadn't geared up yet, and stocks of rubber knobs had to run out first. You MIGHT find some on early serial '46's, as supplies of steel knobs would have been used up, but I haven't heard or seen of any.
If you can get a couple cheap, by all means put them on e-bay: don't take the chance they disappear (remember what iron brings now). Last I looked, they were bringing 40$ on average, but that could be higher now.
I have a '46 H, that has a P code rear end, with the cast iron shift knob...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
