Posted by Charles Todd on April 07, 2008 at 19:49:33 from (205.242.95.135):
I have searched the archives on the subject and didn't quite find the answer I was looking for.
I got all of my hydraulics back together and installed my freshly rebuilt remote valves. The valves worked almost a good as new! Quite proud of myself for pulling that one off.
The problem reared its head when I went to unload a Mott (Alamo) 88" Flail Mower from my trailer. I had to gap the throttle wide open to raise it over the side of the trailer. I figure the Mott mower weighs 1000-1200 lb. The loader has a 3000 lb lift rating @ 1800 psi. I know the system relief is 1650 psi. When I put the load to it, the diverter valve started by-passing (squealing). I have not investigated too deep but there is a set-screw on the diverter. Should I adjust this or look deeper (relief valve)?
Sorry for being long winded, it has been a long day and my mind is racing. I have not installed a gauge in-line to see what actual psi I am delivering to the remotes, but i know it seems weak. Also the power steering can be difficult at times too... May be related?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.