Posted by Charles Todd on March 11, 2008 at 16:44:44 from (205.242.95.130):
In Reply to: Re: 504 Farmall posted by allnightshifter2 on March 10, 2008 at 21:43:32:
My 504 diesel has pulled a Vermeer 504C baler yearly, Massey-Furgeson 10' tandem disk, John Deere 9' offset disk (just not real deep), and occasionaly a Reynolds 4 yd earth-moving scraper (too much for the old tractor, but gave it hell trying). Also I tried a 5 point chisel plow... Yeah right, it was like an anchor. It is a good 50 hp tractor, especially if it has a functional TA. If you plan to pull or lift anything heavy (like round bales or large equipment), find some front weights! With out weights, I can it in 3rd and ride a wheelie for a short piece, very light on the nose. I removed about 700-800 lb of weights off the front of mine when I installed my loader.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
