Posted by Joe Schmitt on February 11, 2008 at 06:55:57 from (216.222.170.132):
In Reply to: 4568 IHC posted by RIVIR on February 09, 2008 at 13:25:01:
RR is right there are 2 bellhousings a #1& #2 I believe your 4568 has a #2 I think you will need a #1 to go to a big Cat or Cummins. Be aware of the rpm and tourqe differences on the bigger inline 6`s. They turn slower and have way more tourqe.The transmission & transfercase are designed for the V800: 2650rpms. If you run in a higher gear to maintain the same ground speed you will have trany or tranfercase problems. Also you will have to lenghten the frame. A Detroit 6V92 or 8V92 may be a better match.( not nessesarily better motors ).I considerd all this on my 4586, I rebuilt the V800. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
