Posted by CityBoy-McCoy on December 26, 2007 at 05:05:36 from (209.214.105.135):
In Reply to: C-113 sleeves. posted by georgeky on December 25, 2007 at 20:18:18:
Hi, George: There is a change in the C-113 block about serial number 310,000 (Super A serial number). Above that and the sleeve bore in the block is larger. Basically, it is a 123 block sleeved down to 113. So, if you get the older sleeves and your block is above 310,000, they will simply fall into the bores in the block and will not seal. Or, vice versa if you have an old 113 block and get newer sleeves - they won't go in at all. Sorry to create confusion for you, old Chap, but it might help if you clarify what block you have. A block from a (non super) C would, I believe, take the older sleeve with the smaller outside diameter - like the Super A's below 310,000. Sorry I don't have the O.D. dimensions, but others may post with that information for you. Hope this helps prevent you from getting the wrong sleeves. mike durhan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: The Old Gold National Antique Tractor Show - by Cindy Ladage. Over the fourth of July weekend, the Illinois State Fairgrounds in Springfield, Illinois, was the site of the Old Gold National Antique Tractor Show. Tractors of all makes and models were displayed and separted into categories by their age. Deere, Oliver and even a Wards and Keck Gonerman were part of the crowd. A sea of red International Harvester's seemed to be the the model with the biggest showing. The crowd was decent for the scorching July heat. The opening day started o
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
