Posted by Janicholson on November 16, 2007 at 12:55:33 from (199.17.6.122):
In Reply to: Titan 10-20 posted by LenNH on November 16, 2007 at 09:41:32:
Grandpas Titan was being operated by my uncle. He got it into a marshy area and stopped. By the time he got it into reverse and began backing, he had killed the engine. They (my dad and uncle told me) were near impossible to start when hot. And it was August. Trying to start it had worn his arms off. He had a bright idea. He went and got the haymow rope and came back to where the neighbor was working a team of morgans. He got the neighbor to come help. They wrapped the rope around the belt pulley of the titan about 15 turns, with the first turns overlapping. With the horses in position, the neighbor flicked the reins and said Gedup. They stepped into the load, and the pulley spun up the engine. It started on the second TDC and started spitting rope. The rope tangled in the gizmoes and clutch arms on the pulley and began winding in!!! The horses were taken by suprize and pulled backward off their feet and dragged for 4 yards in there harnesses. The rope broke, the horses leaped up and took off. They were not hurt, just wound to the mak with fright. The rope was whapping the grouns like a bull whip with authority. Well it took another three hours to get the tractor out with boards and shovels. It took three weeks to get the horses back into condition to pull tillage with any control. My uncle had to buy a new mow rope, and work for a month at both home and the neighbors!! I hope this is what you had in mind for a story. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
