Posted by the tractor vet on October 29, 2007 at 21:27:29 from (75.19.120.169):
In Reply to: Farmall 756 TA posted by MF40Industrial on October 29, 2007 at 20:26:57:
That all dependes on who is doing it. Now it has been awhile since i put one in and not sure of the cost on them anymore but lets say that a good HD T/A cost around 650 plus ya need to do the clutch at this time since ya have that apart so you'll have around 225-275 in that with the bearings and ya need a gskt kit and they are around 65 bucks or where and a MCV spring kit and gskt kit that will run about 60 bucks . Now ya may need a new MCV pump and that might be around 450 now ah days then ya want to install a new PTO input shaft and bearing and that will run ya around 125-150 . Now as for the labor in todays market figuren about 23-26 hours on everything and plus grinding the flywheel about 1200 bucks by my rate. God and to think that back when i would do them all day long on a 706-756-856 for 475 bucks with no cab on the labor. And that labor rate is now at 45an hour. Hate to figure what it would be at say 80 bucks and hour.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
