Posted by Wardner on September 22, 2007 at 14:35:47 from (4.154.240.172):
In Reply to: Re: cub tach posted by Wardner on September 22, 2007 at 11:04:49:
I have a little more time now so I will address your question more thoughtfully.
There are at least three different IH tach configurations made by Stewart-Warner. But there may be 10-20 different part numbers. The large large number of part #s is due to the location of the PTO line printed on the face and the number of speeds in the transmission.
Some tachs use a 0-2400 rpm dial
Some tachs use a 0-3000 rpm dial
Some tachs (gas start diesel and 9 series gas engines) run backwards.
The Cub uses the 0-2400 calibration. It has three speed bands on the upper half of the dial. You should be able to use any IH tach that is calibrated for 0-2400 and has the 0 point on the right side. Let me know of you need a picture.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
