Posted by J.J. from Afton on September 21, 2007 at 13:22:19 from (66.41.83.1):
In Reply to: Run over by my Cub posted by Farmall Ed on September 21, 2007 at 05:36:42:
Good to hear you made it out okay. A couple guys almost got up at tech school first year I was up there. They were splitting a JD 4020 and neglected to take the all the suitcase weights off the front, and did not put a splitiing stand on the front before pulling the frame bolts. There was one guy standing on each side, they pulled the last bolt and went to roll it forward, than just hear this huge crash. The front end flipped down and slammed against the floor, and the frame rails just missed their heads by about 2 inches. Also had a Case 1070 flip to the side after a couple guys split it casue they didn't wedge the bolster and front axle to prevent it from doing so. Instructor sure let those guys have it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.