Posted by Jamie Larson on September 20, 2007 at 16:19:59 from (208.53.229.235):
Grandpa's M had a charlynn power steering unit on it. I have rebuilt the motor and the water pump was shot. I got another from a neighbor fan and all, so I tossed the other. The fan grandpa had on it was obviously not from an M and had been cut to fit in the shroud. There was also much less pitch to the blades. With the new fan and water pump the fan hits the power steering pump belt. What do I need to do to correct this? Extending the fan forward with spacers does not seem to be an option as then the drive to the water pump will not work. Any ideas will be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Pefect Collection - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I thought it would make for some interesting discussion for many of you to post what would be considered your dream or perfect antique tractor collection of five tractors, assuming room for storage and cost were not a factor. I have posted my "Perfect Collection" on the Farmall board. List any brand preference but keep
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
