Posted by dennis vanpopering on August 30, 2007 at 18:49:45 from (69.50.34.228):
In Reply to: Re: international i-4 posted by Harold H on August 30, 2007 at 16:29:46:
i will tell you a little about putting a 3point on a tractor this narrow.the first problem is i have to get on the rear not the front like most tractors.i made every thing but the bottom bars i bought them new at orchilens,in dodge city.i used 3 inch thick walled pipe then i found a pipe that fits tight.it was only 14 inches wide.then i used 3x4 tubing for the arms.i used 3x8inch cylinders,standing upright.about3/4 way back on the arms.i got it done today,it has 24inches of lift,i dont know if that is right or not.it works better than i wanted it to.i will post a picture when i figure out how.thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
