Posted by Hugh MacKay on August 18, 2007 at 07:30:02 from (209.226.247.171):
In Reply to: IH 70 Plow ?? posted by littlemackinawfarmall on August 18, 2007 at 02:29:53:
Wade: Excellent plow, plow chief bottoms are a down side, super chief are much better and easier to find wear parts for. You can change the bottoms to super chief, but it will require complete change including frog. The plow frame and trip beams are the same for both.
Size of cylinder depends much on tractor as anything. Anything over 3" bore will lift it, however different sizes control speed of lift. 4" will be slower than 3". You may find 3" too fast, personally I'd go with 4". That is what I used with No. 60 and 560 tractor. The linkage on a 70 is very similar, but it does raise higher and goes deeper, thus the same cylinder would be slower on a 70.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Pefect Collection - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I thought it would make for some interesting discussion for many of you to post what would be considered your dream or perfect antique tractor collection of five tractors, assuming room for storage and cost were not a factor. I have posted my "Perfect Collection" on the Farmall board. List any brand preference but keep
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
