Posted by old on August 16, 2007 at 09:17:39 from (4.244.186.10):
In Reply to: Re: Stuck Cub posted by the Unforgiven on August 16, 2007 at 07:22:52:
Well since I have been working on engines on and off since I was 18, some 30 plus years ago I have tried it all coke, oil, diesel, etc. etc. and have found out none have ever worked as well as tranny fluid. AS for cost a can of PB will run you $3-4 and a cheap wally world tranny fluid less then $2 and you get 2 or 3 times as much. And since you trhow away the tranny fluid when done why spend so mush to do the same thing. Ya it doesn't always work and nothing will, but if its going to pop free tranny fluid is more likely to do it then most other things plus it does remove rust and soaks in where plan oil will not
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
