Re: Farmall A temperature gauge

Posted by Jim Becker on August 06, 2007 at 19:53:57 from (71.244.13.18):

In Reply to: Farmall A temperature gauge posted by Dick Birch on August 04, 2007 at 18:06:30:

The gauge is in the attachments section of the A/B Parts Catalog, same page as the shutters.

The bracket goes on the front/top of the governor housing, using one existing bolt and a second one (5/16 x 1/2) in the open hole on the govermor housing. The hole should already be tapped for 5/16. The sender end of the gauge goes into the lower coolant elbow. Tractors without the gauge usually do not have the hole in the elbow but do have a flat place to drill for it. If present, the hole should be threaded to a pipe thread.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]