|
Farmall & IHC Tractors Discussion Board |
Re: Farmall B coil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on July 27, 2007 at 15:45:49 from (4.244.57.15):
In Reply to: Farmall B coil posted by Dave H (MI) on July 27, 2007 at 15:09:17:
One side of the coil goes to the ignition switch and the other side to the points. When the points close it then puts that side of the coil to ground and when they open that side is an open circuit. I would check you points and make sure they are set right and clean. Pull the cap off turn on the ignition and by hand open and close the points holding the center wire from the coil close to the block. When you do that you should get spark, if you don't watch the points if you don't see spark at the points the points could be bad or need cleaned. You could also have a bad cap and or rotor or maybe you forgot to put the rotor back in. Yep happens to the best of us and I did that just the other day and low and behold I had no spark at the plugs. LOL
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|