Farmall & IHC Tractors Discussion Board |
Re: '39 H's
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on July 26, 2007 at 19:02:58 from (204.249.178.32):
In Reply to: Re: '39 H's posted by Dalton S. on July 26, 2007 at 14:30:52:
Hard telling what the pre-production models were. As others have mentioned, the "slot top" trans/rear end cover and accompanying seat were on SN 501 thru 15697. For whatever reason the seat and trans cover on yours could have been changed. Look at the casting code on the front right of the cover, in the form of 7*8*I or July 8, 1939; J is 40, if it is a K (1941) or higher it is not the original cover for a 39 or some 40 models. I don't know the month it was changed in 1940, but if production was fairly even it was before mid-year. Those codes are pretty much fool proof. Also, if yours is a 1939, all casting codes on most major parts will have an I for the year. If an early 40, it can have both I and J codes.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|