|
Farmall & IHC Tractors Discussion Board |
1066 lift arm fix?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Curtis Gray on July 26, 2007 at 09:44:59 from (72.161.157.240):
I have a 1973 model 1066. When backing up with my scraper blade attached, and the blace hits a hump, the shaft that is connected to the lift arm control inside the tractor, jumps over the shaft that actually raises the hydraulics for the lift arms. The only solution is to remove the 6 bolts on the cover that the turnbuckle is attached to, get inside the tractor, and re-arrange the 2 shafts in their proper arrangement. Has anyone tried to have a different shaft machined that would prevent this from occuring? Surely these tractors are old, and I believe that many of the models built around the same time as mine are prone to this problem... Thanks for reading.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
