Farmall & IHC Tractors Discussion Board |
Re: Start in 3rd or 4th - Farmall 130?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by City-Boy McCoy on July 23, 2007 at 15:07:49 from (70.149.220.126):
In Reply to: Start in 3rd or 4th - Farmall 130? posted by Dave NY on July 23, 2007 at 07:09:02:
Dave: I can double clutch a Formula Ford racecar, lap after lap, but I cannot for the life of me double clutch a farm tractor. So... In my opinion, there is no real good answer; both methods are flawed for me. Start in 4th all the time and I will eventually need to replace my clutch. Start in a lower gear and shift, and I will finally need to replace the gear from grinding. I try to get a little tractor movement going in high, stab the clutch pedal to let the engine recover, let the clutch out again while still rolling, and get going a little faster, stab the clutch pedal again, gaining speed each time. It seems to work pretty well with minimum slippage and wear to the clutch and no wear to the gears from grinding. It's probably the WORST way of getting it done, but I've never had to replace a clutch and never had to replace a gear. mike durhan
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|