|
Farmall & IHC Tractors Discussion Board |
Re: metric bearings?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Chris Heinzle on July 15, 2007 at 11:26:47 from (216.229.21.133):
In Reply to: Re: metric bearings? posted by Farmall MD on July 15, 2007 at 11:18:41:
Doug,
Two of the 4 bearings that I have out so far I measured with a digital caliper. The input shaft pilot bearing (BOWER MU5205) measures 2.045 OD and .982 ID. In metric that is almost exactly 52mm and 25mm. The part number actually crossed to a metric bearing from an online bearing retailer. The other one is an IH ST221, 2.165 (55mm) ID, and 4.723 (120mm) OD. Also have ST239 and ST203 out so far.
Does that sound right?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
