Farmall & IHC Tractors Discussion Board |
used your formuala for ih 300, correct me if wrong
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by arthur ward on July 14, 2007 at 09:03:24 from (74.33.185.236):
In Reply to: Re: horsepower of a farmall 450 posted by Jason Simmerman on July 14, 2007 at 06:21:31:
i would then assume an IH 300: pto hp of 34 engine rpm of 1750 this would mean that the IH 300 has about 155 ft. lbs. of torque if i am not mistaken. than would be the reason it is capable of pulling a 3 bottom plow. if i am correct then could you please verify my math and if i am not, could you tell me why? thanks
Replies:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|