|
Farmall & IHC Tractors Discussion Board |
Re: RINGS--which side is up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on July 13, 2007 at 21:42:35 from (152.163.100.201):
In Reply to: RINGS--which side is up posted by SDE on July 13, 2007 at 21:10:56:
It has been 10 years since I put in new rings. I do have one tore down and went to look and the groove is up. This is a set I put in 10 years ago and I couldn't see a dot, but the manual says if rings are marked top to put that side up. Says nothing about a dot, but I do remember seeing dots on them before. If the instructions that came with rings says dot up, I suspect that is the way you need to install them. It is a little confusing aint it? Maybe a more definite answer will be posted by someone who has replaced them more recently than me.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|