Re: M, SM, H and SH Governors All The Same - Right?

Posted by D Slater on July 11, 2007 at 07:00:09 from (71.164.58.156):

In Reply to: M, SM, H and SH Governors All The Same - Right? posted by City-Boy McCoy on July 11, 2007 at 04:58:55:

Don't know how much of the governors you are referring to. There was some small changes made over the years but basic differances are, drive gears, throttle tube and the casting it goes in and linkage rod length to throttle tube shaft. H used a throttle tube shorter than SH,300 or 350 and those shafts are different from M.SM,400,450. Later throttle tubes or IH replacments had a seal on throttle shaft inside tube. Casting on governor housing that throttle tube goes in is taller on M to 450 than others.

Replies:

• Re: M, SM, H and SH Governors All The Same - Right? D Slater 07:04:24 07/11/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]