Farmall & IHC Tractors Discussion Board |
Re: McCormick-Deering W6
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harold H on July 08, 2007 at 03:54:56 from (69.40.93.218):
In Reply to: McCormick-Deering W6 posted by Ian Browning on July 08, 2007 at 00:03:58:
42" x 10" rear steel and 22 1/2" x 4 front steel was standard on USA reactors. Available rubber sizes in the USA on a very limited basis were; 12.75 x 24 (changed to 12 then to 13.6 modern), 13.50 x 24 (changed to 13 then 14.9 modern), 12 x 30 (13.6 modern) and 13 x 30 (14.9 modern) rear and 6:00 x 16 and 6:50 x 16 front on a limited basis. Since your tractor has 28" rims, obviously different sizes were available in Australia. I would suggest 14.9 x 28 for you tractor since 13.50 x 28 changed to 13 x 28 then to 14.9 x 28 modern. Harold H
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|