|
Farmall & IHC Tractors Discussion Board |
Re: Farmall M clutch replacement
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Theman on February 09, 2000 at 13:53:47 from (204.149.23.2):
In Reply to: Farmall M clutch replacement posted by C.Fitz on February 09, 2000 at 11:31:51:
The previous posts are correct. I did this on my '51 H. One additional bit of advice: Clean all the crud you can out of the torque tube after dropping the belly pump. My tractor didn't have the covers under the throw-out bearing or pump drive couplings and there was a fair amount of dirt and grease in there. I didn't take the time to clean it up and I had stuff falling in my face the whole time I was working on it. Just follow the procedure in the service manual and you'll be OK. One other thing...I put a floor jack under the pump and lowered it SLOWLY out of the tractor. I don't recommend doing this without help. I am fortunate - my wife is a great help in these situations. The all-thread, however, is much safer.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
